It seems like your browser didn't download the required fonts. Please revise your security settings and try again.
Barracuda NextGen Firewall X

This Product is End-of-Life and End-Of-Support

End-Of-Life and End-Of-Support on December 1st, 2020: All Barracuda Firewall X-Series sales will cease; neither new sales nor any renewals will be available. If you currently hold a maintenance and support contract, you will continue to receive our award-winning support and services until your contract expires. Please see the End-Of-Life definition as described in the End of Support and End of Life Information.

How to Configure WAN Interfaces

  • Last updated on

By default, ports p2 and p3 are preconfigured. If you want to configure a WAN interface for either of these ports, you might need to remove the default configurations:

  • Port p2 – Initially, the network interface for port p2 is configured as a dynamic network interface named dhcp. If you want to configure either a static or other dynamic connection besides DHCP (PPTP or PPPoE) on port p2, delete the default DHCP interface. 

  • Port p3 – Initially, port p3 is bridged to port p1. Both interfaces are also configured as management ports in the LAN. To use port p3 for another connection, delete the P1-P3 bridge. However you might lose connectivity to the network from your administrative PC. 

After removing the default configurations for ports p2 and p3, you can reconfigure them as WAN interfaces. For any other ports, just begin configuring the WAN interface. You can configure the WAN interface with either static or dynamic IP address assignment.

Be sure to add the gateway to create the default route over the WAN interface, either when you add or edit a static network interface, or on the NETWORK > Routing page.

Remove the default configurations for port p2 and port p3

If you want to use port p2 or p3, first remove their default configurations.

  1. If you want to use port p2:
    1. Go to the NETWORK > IP Configuration page.
    2. Delete the default DHCP interface from the Dynamic Interface Configuration section.
  2. If you want to use port p3:
    1. Go the NETWORK > Bridging page and delete the P1-P3 bridge.
    2. Go the the FIREWALL > Firewall Rules page. Delete the P1-P3-BRIDGE firewall rule.

Configure a WAN interface

To configure a WAN interface:

  1. Go to the NETWORK > IP Configuration page.
  2. If your WAN interface has a static IP address:
    1. In the Static Interface Configuration section, click Add Static Network Interface.
    2. Configure the static interface settings, including the gateway address.
    3. Click Add.
  3. If you have a dynamic connection such as PPTP or PPPoE:
    1. In the Dynamic Interface Configuration section, click Add Dynamic Network Interface.
    2. Configure the dynamic interface settings.
    3. Click Add.
  4. At the top of the page, click on the warning message to execute the new network configuration.