This article refers to Barracuda Phone System and Snom VoIP Phones.
Snom phones require a minimum firmware version 7.0. for additional information, refer to Snom VoIP Firmware/V7/Automatic Update on the Snom wiki.
Provision the Phone
Use the following steps to configure Snom phones using the Snom web server:
Point a web browser to http://x.x.x.x where x.x.x.x is the IP address of the Snom phone. The web interface displays.
Go to the Setup > Advanced page, and click the Update tab.
From the Update policy drop-down menu, select Update automatically.
In the Setting URL field, enter http:/x.x.x.x/provision/ where x.x.x.x is the IP address of the Barracuda Phone System.
Click Save, then click Reboot.
Reset Factory Defaults
If the phone fails to provision, reset its configuration with the following steps:
Press the Down arrow on the large, round control button.
Press the Up arrow until you see Configuration on the first line.
Press the Right arrow until you see Reset on the second line of the display.
Press the Check mark button.
Enter the Admin Password and press the Check mark button again; the default Admin Password is 0000.
Allow the phone to reboot.
Once the phone reboots, select the language using the Left and Right arrow keys.
Selet your country's dial tone.
Select your country's time zone.
Under Account, enter a single letter or digit, and then press the Check mark button twice.
You can now re-provision the phone.