It seems like your browser didn't download the required fonts. Please revise your security settings and try again.
Barracuda CloudGen Firewall

Wi-Fi AP Authentication Aruba Configuration

  • Last updated on

To authenticate users connected to Aruba access points, you must stream the syslog containing the authentication data to the Barracuda CloudGen Firewall F-Series.

Reference Devices/Versions: 

  • Aruba Controller 651 Version 6.4.1.0
  • Aruba AP 105 
  • Aruba Instant

Enable Syslog Streaming on the Aruba AP

  1. Log into the Aruba Mobility Controller.
  2. Click the Configuration tab.
  3. In the MANAGEMENT section of the left menu, click Logging
  4.  In the Logging Servers section, click New:
    • IP Address – Enter the management IP address of the Barracuda CloudGen Firewall F-Series.
    • Category – Select user.
    • Logging Facility – Select the logging facility to be able to differentiate between multiple Aruba APs.
    • Severity – Select notifications.
  5. Click Add.
  6. Click Apply
    aruba01.png
  7. Click the Levels tab.
  8. Set the Logging Levels in the User logs section to notifications.
    aruba_03.png
  9. Click Apply.

Verify that the Firewall is Receiving the Syslog Data

On the Barracuda CloudGen Firewall F-Series, go to LOGS and open Box > Control > AuthService_wifiap.log . After successfully authenticating, you will see a logged in user <username> with IP <IP address> line in the log. The Wi-Fi access point name is also listed.
aruba_Logs.png