In case your Barracuda NextGen F-Series Firewall gets replaced with a newer hardware revision model of the same model (e.g., from F400 Rev. A to F400 Rev. B.), you must use a configuration backup (PAR file) to restore the configuration on the new appliance.
In this article:
Before You Begin
You must have a working PAR file of the previous configuration. For information on how to back up and restore configurations, see Backups and Recovery.
Step 1. Restore the Configuration on the New Appliance
- Go to CONFIGURATION > Configuration Tree.
- Right-click Box and select Restore from PAR file.
- Go to CONTROL > Box.
- In the left menu, expand Network and click Activate new network configuration.
- Select Failsafe as the activation mode.
In the left menu, expand Operating System and click Reboot Box.
Step 2. (NextGen Control Center C400 / C610 only) Configure the fallback module
Enable a fallback interface and select the fallback module name.
- Go to CONFIGURATION > Configuration Tree > Box > Network.
In the left menu, select Interfaces.
- Expand the Configuration Mode menu and select Switch to Advanced View.
- Click Lock.
- In the Network Interface Cards section, edit the interface.
- Set Fallback Enabled to Yes.
- Select the fallback interface from the Fallback Module Name list:
- Barracuda NextGen Control Center C400 – Select Intel PRO/1000 PCI-Express (82575/6).
- Barracuda NextGen Control Center C610 – Select Intel PRO/1000 PCI-Express (82571/2/3/4 or 82566/7).
- Barracuda NextGen Control Center C400 – Select Intel PRO/1000 PCI-Express (82575/6).
Click OK.
- Click Send Changes and Activate.
Step 3. Select the hardware model
If the appliance revision of the new firewall differs from the previously installed version, you must adjust the Hardware Model. This is necessary because different hardware models typically come with newer network interfaces and thus require appropriate drivers.
- Go to CONFIGURATION > Configuration Tree > Box > Box Properties > Identification.
- Click Lock.
- From the Hardware Model list, select the appropriate model revision.
- Click Send Changes.
- Go to CONFIGURATION > Configuration Tree > Box > Network > Interfaces. A pop-up window opens indicating that the hardware model must be changed.
- Click OK to close the window.
- Click Lock. The Appliance Model will now be automatically adjusted.
- Click Send Changes and Activate.
Step 4. Activate the Network Configuration
- Go to CONTROL > Box.
- In the left menu, expand Network and click Activate new network configuration.
Select Force as the activation mode. The Activation Succeeded message is displayed after the network configuration has been activated.
Restart Barracuda NextGen Admin.