It seems like your browser didn't download the required fonts. Please revise your security settings and try again.
Barracuda CloudGen Firewall

This Firmware Version Is End-Of-Support

Documentation for this product is no longer updated. Please see End-of-Support for CloudGen Firewall Firmware for further information on our EoS policy.

How to Configure WAN Optimization for TINA VPN Tunnels

  • Last updated on

You must apply WAN Optimization for both TINA VPN tunnel endpoints separately. First, enable and configure WAN Optimization for the Barracuda CloudGen Firewall. Then configure WAN Optimization in the TINA VPN tunnel settings. 

Configure WAN Optimization

  1. Go to CONFIGURATION > Configuration Tree > Box > Assigned Services > VPN-Service > WAN Optimization.
  2. Click Lock.
  3. Select yes from the Enable WAN Optimization dropdown.
  4. You can also specify the following settings:

    SettingDescription

    Log Level

    The log verbosity of this service. You can select a value from 1 (lowest) to 9 (highest).

    Max. Number of Connections

    The maximum number of concurrent connections that can be handled.

    Max. Number of Partners

    The maximum number of concurrent VPN transports using WAN Optimization. Default: 128

    Used Memory (MB)
    (Advanced View)

    The amount of RAM reserved for the WAN Optimization dictionary.

    Used Disk (MB)
    (Advanced View)

    The amount of hard disk space allocated by the WAN Optimization dictionary.

    The amount of allocated memory and hard disk space is adjusted automatically by the Barracuda OS, depending on the hardware that the Barracuda CloudGen Firewall is running on. Change the Used Memory (MB) and Used Disk (MB) settings with care. Generally, the ratio between the Used Memory and Used Disk settings should be between 1:50 and 1:80.

  5. Click Send Changes and Activate.
  6. Repeat steps 1 to 6 for the remote VPN service.

Configure the TINA VPN Tunnel Settings

  1. Create a new TINA VPN tunnel or edit the settings of an existing tunnel.
  2. In the tunnel configuration window, click the Advanced tab.
  3. Specify the following WAN Optimization settings:

    SettingDescription
    WAN Opt Policy From this list, select default.
    WANOpt Transport

    Specifies if WAN Optimization is enabled or disabled for this VPN transport .

    • Stream compression for the VPN transport is automatically disabled when WAN Optimization is enabled.
    • Packet compression of WAN-optimized traffic for the VPN transport is automatically disabled when WAN Optimization is enabled. Non-WAN-optimized traffic passing the transport is still packet compressed.
  4. Click OK.
  5. Click Send Changes and Activate.
  6. Repeat steps 1 to 6 for the remote VPN partner service.

Viewing the WAN Optimization Compression Rate

To view the compression rate achieved by WAN Optimization, enter the following at the command line: 

ktinactrl wanopt stat

For more information, see ktinactrl.