We use cookies on our website to ensure we provide you with the best experience on our website. By using our website, you agree to the use of cookies for analytics and personalized content.This website uses cookies. More Information
It seems like your browser didn't download the required fonts. Please revise your security settings and try again.
Barracuda CloudGen Firewall

IPsec Settings

  • Last updated on
IKEv1
SettingValue(s)
*=default
Description
Timeout30The maximum period to wait until the request for IPsec tunnel connection establishment must be approved by the remote peer.
Tunnel check interval [s]30The interval between queries for a valid exchange that is assignable to an IPsec tunnel.
Dead Peer Detection Interval [s]5

Tunnels can be configured to be Active or Passive. An active tunnel is capable of establishing a connection while a passive tunnel is waiting for a connection request.

This parameter sets the interval between keep-alive checks on the remote peer.

Use IPSec dynamic IPs

Selected

Deselected

If the service is connected to the Internet via a dynamic link (dynamic IP address), select Yes. The server IP address is not yet known at configuration time and IKE then listens to all local IP addresses.
IPSec Log Level0The debug log level of IKE. The debug log may be very “noisy.” Do not select a log level greater than 0 if the log is not required for solving an issue.
Pre-shared key (PSK)-Holds the pre-shared IKE key.
IKEv2
SettingValue(s)
*=default
Description
Start IKEv2

Selected

Deselected

If selected, IKEv2 will be used.

If deselected, IKEv2 will be disabled and some additional memory will be saved.

IKEv2 Make Before Break

Selected

Deselected

Selecting this option creates a duplicate of the IKE and all IPsec SAs, and the deletes the old ones. This setting requires that both peers can handle overlapping SAs.
Last updated on