It seems like your browser didn't download the required fonts. Please revise your security settings and try again.
Barracuda Campus Barracuda Campus
Barracuda XDR
Overview Documentation Materials

Setting up Tanium Collector

  • Last updated on

This setup is for the XDR Collector only. If you are using a physical or virtual sensor, refer to Integrating Tanium Connect.

To set up Tanium Collector, do the following:

  • Enable Tanium Collector
  • Install the XDR Collector

Enable Tanium Collector

  1. In Barracuda XDR Dashboard, navigate to Administration >  Integrations.
  2. On the Tanium Collector card, click Setup.
    2024-02-29_11-13-39.png
  3. Select the Enable check box.
    2024-02-29_11-14-10.png
  4. Click Save.

Install the XDR Collector

When collecting logs from one or more integrated data sources, always set up the XDR Collector on a dedicated host server. Don't use an existing server because the amount of data produced by logs can impact critical infrastructure.
Previous Article Next Article