Default Port Configuration
Label | OS Notation | Speed/Type | Management Port |
---|---|---|---|
1 | port1 | 10/100/1000 MBit RJ45 | X |
2 | port2 | 10/100/1000 MBit RJ45 | |
3 | port3 | 10/100/1000 MBit RJ45 | |
4 | port4 | 10/100/1000 MBit RJ45 |
Hardware Specifications
Component | Specifications |
---|---|
CPU | VIA 500 MHz |
Memory | 2 GB |
Flash Disk | 4 GB |
USB | 2x USB 2.0 |
Form Factor | Desktop |
Dimensions (W/D/H) | 374 x 190 x 50 mm 14.7 x 7.4 x 1.9 in |
Net Weight | 3.5 kg / 7.7 lbs |
Power Supply Input Voltage | 100 - 240 V, AC |
Power Supply Output Voltage | 12 V, DC |
Power Supply Voltage | 47 Hz - 63 Hz |
Power Supply Watts | 60 W |
Storage Temperature | -20 °C - +70 °C |
Operation Temperature | 0 °C - 40 °C |
Relative Humidity | 5% - 95%, non-condensing |
Certifications | CE, FCC, ROHS |
Wi-Fi (F101 only) | 802.11 b/g/n up to 150 Mbps single antenna extended range |
Status LEDs and Acoustic Signals
Your appliance is equipped with a variety of LEDs. One of them is the Status LED. It is labeled either with a heart symbol or the term Status. It indicates the appliance’s operational state by changing colors between green, orange and red, and by changing between blinking and steady glowing. The table below shows the different meanings of the different glowing states.
Color | Glowing State | Meaning: Installation | Meaning: Normal Operation or Active Recovery Technology (ART) Operation |
---|---|---|---|
Off | Off | Appliance is powered off or installation has not initialized far enough for LED control when installation is started. | Appliance is powered off. |
Green | Blinking | Normal installation. | Appliance is either booting, shutting down, or performing a system update. |
Green | Steady | Installation was completed successfully. Appliance is halted for reboot or installation was not yet initialized far enough for LED control. | Barracuda NextGen Firewall is up and running. |
Red | Blinking | Error during installation. | An error has occurred, preventing the Barracuda NextGen Firewall from entering the up state. |
Red | Steady | - | Appliance is halted and may be disconnected. |
Orange | Blinking | - | - |
Orange | Steady | - | Appliance is in ART mode. |
Acoustic Signal | Frequency | Meaning |
---|---|---|
Beep | 1 time | Unit starts booting |
Beep | 3 times | Installation is completed successfully and appliance is halted for reboot. After reboot, one beep indicates booting. |
Serial Console Port
In order to establish a console connection to the appliance using an RJ45 serial cable, you need to configure the serial port on the terminal using the following parameters:
Parameter | Value |
---|---|
Baud | 19200 |
Bits | 8 |
Stop bit | 1 |
Parity | None |
Handshake | None |