Barracuda Firewall Admin
After updating a system, you must also download Firewall Admin with the same version. Firewall Admin is backward-compatible. That means you can manage 7.x and 8.x F-Series Firewalls and Control Centers with Firewall Admin 8.x.
Always use the latest version of Barracuda Firewall Admin.
Important Note for Users operating Firmware 7.2.5 or 7.2.6
IMPORTANT NOTE
Ensure that the partition layout of your firewall/Control Center applies to the values in the table of paragraph
Disk Space Requirements of the article
Migration from 7.x - 8.0.0 to 8.0.3 .
- If you operate a firewall that was shipped from the factory with firmware 7.2.6 or if you have already repartitioned the hard disk and performed a fresh install of firmware 7.2.6, then the hard disk already has a partition layout that is suitable for firmware 8.x.
In this case you can upgrade directly to firmware 8.x without repartitioning the hard disk. - If you operate a firewall with firmware version <= 7.2.5, you must repartition the hard disk with the layout listed in Migration from 7.x - 8.0.0 to 8.0.3 and fresh install firmware 7.2.6. After that, you can update to 8.x without repartitioning.
DNS
IMPORTANT NOTE
The new DNS service is based on the commonly known BIND standard. In case a recursive DNS server is configured, the DNS service automatically configures empty zones. This prevents the firewall from sending meaningless queries to Internet servers that cannot handle them.
Note that this option cannot be disabled when the firewall is configured to operate in recursive mode.
When migrating to firmware 8.0.3, forward zones from your current configuration will be deleted and not migrated.
Read the Release Notes, especially the Known Issues section, for the firmware version that you want to update to.
For more information, see 8.0.3 Release Notes .
Migration Path to 8.0.3
You can upgrade to firmware 8.0.3 from the following firmware versions:
